摘    要
 
本文介紹了電磁爐的工作原理、設計要求，并提出用AT90S8535單片機來設計電磁爐，詳細介紹電磁爐硬件、軟件的實現過程。硬件主要介紹了風扇、蜂鳴器驅動電路,電流測量電路，電壓測量電路，溫度測量電路，IGBT管控制電路，主控板電路分析，最后用Altium Designer6.5軟件模擬硬件實現；軟件部分主要分成鍵盤掃描，顯示面板控制，功率控制，溫度控制，風扇、蜂鳴器控制，定時控制。
關鍵詞：電磁爐；AT90S8535；硬件；軟件；
 
ABSTRACT
 
This article introduced the electromagnetism stove principle of work and the design request, and proposed designs the electromagnetism stove with the AT90S8535 monolithic integrated circuit, and detailed introduction electromagnetism stove hardware, software realization process. The hardware mainly introduced the ventilator and the buzzer actuate the electric circuit, the electric current metering circuit, the voltage measurement electric circuit, the temperature survey electric circuit ,the IGBT tube control circuit, the host to control the board circuit analysis, finally uses Altium Designer6.5 software to simulate the hardware realization; Software partial mainly divides into the keyboard scanning, the demonstrates of kneading board control, the power control, the temperature control, the ventilator, the buzzer control, timed  control.
Key words: Electromagnetism stove; AT90S8535; Hardware; Software;
 
 
 
 
 
 
目 錄
　
1 引言 ----------------------------------------------------------------1
1.1 芯片特性簡介-----------------------------------------------------1
1.2 電磁爐加熱原理---------------------------------------------------2
1.3電磁爐工作原理----------------------------------------------------2
1.4電磁爐設計要求----------------------------------------------------3
2 系統硬件設計---------------------------------------------------------3
2.1 風扇、蜂鳴器驅動電路---------------------------------------------4
2.2 電流測量電路-----------------------------------------------------5
2.3 溫度測量電路-----------------------------------------------------6
2.4 IGBT管控制電路--------------------------------------------------7
2.5 電壓測量電路-----------------------------------------------------8
2.6 主控板電路分析---------------------------------------------------9
2.7 硬件模擬實現-----------------------------------------------------10
3 系統軟件設計---------------------------------------------------------13
3.1 程序流程分析-----------------------------------------------------13
3.2 功率調節模塊-----------------------------------------------------14
3.3 顯示模塊---------------------------------------------------------14
3.4 系統資源分配-----------------------------------------------------16
3.5 軟件總體實現-----------------------------------------------------16
4 結語-----------------------------------------------------------------45
注釋-------------------------------------------------------------------47
參考文獻---------------------------------------------------------------48
附 錄------------------------------------------------------------------49
致 謝------------------------------------------------------------------50