資源包括標準DOC格式正文共40頁 附制件圖.dwg 裝配圖1.dwg 裝配圖2.dwg 裝配圖3.dwg 零件圖1.dwg 零件圖2.dwg 零件圖3.dwg

摘要

本說明書主要是闡述了有關濾油器支架模具設計的基本過程和其主要計算。全文共由四章組成，他們的內容如下所述。
第一章是設計濾油器支架模具的工藝方案的確定，主要根據所給制件特點加以分析，設計出合理的模具，這里共設計出三套模具。第二章是落料拉深復合模的設計，其中包括一些典型結構的選擇和一些非標準零件的設計。第三章是沖孔切邊復合模的設計，包括各種模具零件的選擇和一些零件尺寸的計算。第四章是彎曲翻邊復合模的設計，此章除了沿用了相關類似模具結構外，還進行了簡單的計算和零件設計。
鑒于本人的水平所限，在設計中肯定有不足之處存在，也可能有錯誤出現，懇請評閱老師和各位讀者包涵并且批評指正。

關鍵詞： 模具 復合模 零件

Abstract

This paper is main elaborates the basic mould design course of the sieve oil implement’s bracket,and expounds the main calculation course for it.
There are four parts in this paper, their content as follow.
The first chapter is settling the project of the mould design’s craft to the sieve oil implement’s bracket. It main contains the analysis of the sieve oil implement’s bracket’s characteristics. Make sure design three suitable moulds. The second chapter is the design of the blanking and drawing compound dies. It contains the choosing of the typical framework of the dies. The design
of some accessory. The third chapter is the design of the piercing and trimming compound dies. It contains the choosing the caculation of accessory. The forth chapter is the design of bending and flanging compound dies. In addition to using the similar framework of the dies, it contains some calculation and design of accessory.
In view of my limited knowledge,I could have made some mistakes in this paper, I wish my teacher and the readers could help me correct it, thanks!

Keywords: mould compound dies accessory


目錄
第一章 工藝方案的確定………………………………………………………………4
第二章 落料拉深復合模的設計………………………………………………………7
第三章 沖孔修邊復合模的設計………………………………………………………19
第四章 彎曲翻邊復合模的設計………………………………………………………30
畢業設計總結……………………………………………………………………………39
參考文獻…………………………………………………………………………………40